1. Introduction
Streszczenie: Wprowadzenie do Copley Motion Objects (CMO) – biblioteki obiektów COM do sterowania serwonapędami Copley przez sieć CANopen z aplikacji Windows (VB 6.0, VB .NET, LabVIEW): uproszczony dostęp do funkcji CANopen, architektura systemu (aplikacja → CMO → sterownik CAN → karta CAN → napędy) oraz wymagania: komputer i system, oprogramowanie, karta CAN, firmware napędu.
EN: Introduction to Copley Motion Objects (CMO): COM-based CANopen control of Copley amplifiers, architecture and system requirements.
Dotyczy: Copley Motion Objects (CMO, biblioteka COM CMLCOMLib) – sterowanie serwonapędami Copley CANopen z PC (Windows; VB 6.0, VB .NET, LabVIEW)
Źródło: dokumentacja producenta (Copley Motion Objects Programmer’s Guide); tabele przepisane z obrazów na tekst – opracowanie Multiprojekt
This chapter provides an overview of Copley Motion Objects
1.1 Windows-Based Control of Copley Amplifiers
1.1.1 Simplified Access to CANopen Functions
The Copley Motion Objects simplify creation of Windows-based software for the control of Copley Controls amplifiers over a CANopen network. They give programmers direct access to an amplifier’s CANopen functions without having to learn the complexities of CANopen objects. Copley Motion Objects were built using the Microsoft Component Object Model (COM) architecture, and are fully automation compliant. This means that any Microsoft COM compliant software can access the Copley Motion Objects.
1.1.2 Architectural Overview
The following diagram illustrates the Copley Motion Objects/Microsoft COM model.
Diagram description (text version): Copley Motion Objects / Microsoft COM model. On the PC with Microsoft Windows the layers are, from top to bottom: COM-compliant application code ↔ Copley Motion Objects ↔ CAN interface driver ↔ CAN interface card. The CAN interface card is connected through the CAN network to several Copley CANopen amplifiers.
1.2 Basic System Requirements
1.2.1 Computer and Operating System
Minimum hardware requirements:
- CPU: Minimum 400 MHz
- RAM: Minimum 128 MB
Operating Systems Supported: NT, 2000, XP.
1.2.2 Software
Copley Controls CME 2 software (latest released version) for tuning and configuration of the amplifier.
The Copley Motion Objects were built using the Microsoft COM architecture and are fully automation compliant. Any COM-compliant software can access them. This includes, but is not limited to, VB 6.0, VB .NET, Visual C++, and LabVIEW.
1.2.3 CAN Interface Card
The PC on which Copley Motion Objects is installed needs a CAN interface card for communication with the CAN network. CMO currently supports Copley, Kvaser, IXXAT, National Instruments, and Vector. The current list of supported CAN interface cards can be obtained from the Copley Controls website (http://www.copleycontrols.com).
NOTE: Only the drivers from Vector are supported for the Vector card.
1.2.4 Amplifier Firmware
Use of Copley Motion Objects requires the latest version of Copley Controls amplifier firmware. The latest version can be downloaded at: http://www.copleycontrols.com/Motion/Downloads/firmware.html
Słowa kluczowe
Copley Motion Objects, CMO, COM, CMLCOMLib, CANopen, karta CAN, Windows, VB 6.0, VB .NET, LabVIEW, wymagania systemowe, architektura

No comments to display
No comments to display