Appendix E: Error Codes
Streszczenie: Kody błędów zwracane przez napęd w odpowiedzi „e <kod>” na komendy ASCII, np. 3 – nieznany kod komendy, 9 – nieznana zmienna, 10 – wartość poza zakresem, 11 – zmienna tylko do odczytu, 33 – błąd składni komendy ASCII.
EN: Error codes returned by the amplifier in response to ASCII commands.
Dotyczy: serwonapędy Copley Controls z interfejsem ASCII (RS-232, sieć multi-drop CAN), program CME 2
Źródło: dokumentacja producenta (Copley Controls ASCII Interface Programmer’s Guide); tabele przepisane z obrazów na tekst – opracowanie Multiprojekt
Most ASCII Interface commands can return an error message in the format “e <code>” where code is one of the error code numbers described below
Error codes
| Code | Meaning |
|---|---|
| 1 | Too much data passed with command. |
| 3 | Unknown command code. |
| 4 | Not enough data was supplied with the command. |
| 5 | Too much data was supplied with the command. |
| 9 | Unknown variable ID. |
| 10 | Data value out of range. |
| 11 | Attempt to modify read-only variable. |
| 14 | Unknown axis state. |
| 15 | Variable doesn’t exist on requested page. |
| 18 | Illegal attempt to start a move while currently moving. |
| 19 | Illegal velocity limit for move. |
| 20 | Illegal acceleration limit for move. |
| 21 | Illegal deceleration limit for move. |
| 22 | Illegal jerk limit for move. |
| 25 | Invalid trajectory mode. |
| 27 | Command is not allowed while CVM is running. |
| 31 | Invalid node ID for serial port forwarding. |
| 32 | CAN Network communications failure. |
| 33 | ASCII command parsing error. |
Słowa kluczowe
kody błędów, error codes, e 33, błąd składni, unknown variable, data out of range, read-only variable, CAN communications failure, CVM
No comments to display
No comments to display